DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Open, short in signal or ground circuit
- Poor connection or damaged connector
- Faulty knock sensor
|
| Enable Conditions |
Case1 |
- Knock detection function active
- Engine speed is higher than 2656RPM
- Air mass is higher than 0.25g/stroke
- Engine coolant temperature (ECT) is higher than 65.25°C (149.45°F)
|
| Case2 |
- Knock detection function active
- Engine idle
- Air mass is higher than 0.25g/stroke
- Engine coolant temperature (ECT) is higher than 65.25°C (149.45°F)
|
| Threshold Value |
Case1 |
- Magnitude of deflection of the knock signal is below 0.195V.
|
| Case2 |
- If the absolute value of the difference between knock noise signal and filtered signal is below than 0.05866V.
|
| Diagnostic Time |
|
| MIL ON Condition |
|