DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
Case1 |
|
- Poor connection or damaged connector
- Faulty ECT sensor
- Faulty cooling system
|
| Case2 |
|
| Enable Conditions |
Case1 |
- No relevant failure
- Battery voltage is higher than 6V
- Coolant temperature at start is lower than 76°C (169°F)
|
| Case2 |
- Battery voltage is higher than 11V and lower than 16V
- Coolant temperature at start is higher than 76°C (169°F)
- Intake air temperature is higher than -10°C (14°F) and lower than 70° C (158°F)
- Ambient temperature is higher than -10°C (14°F)
- More than 250s. (cumulative) part load driving condition (Engine RPM is higher than 1400RPM, vehicle speed is higher than 22mph and MAF is higher than 20kg/h)
- More than 200s. (cumulative) low load driving condition (Trailing fuel cut off or idle with vehicle speed is lower than 12mph)
|
| Threshold Value |
Case1 |
- When water temperature is not changed comparing with it at the time of engine start
|
| Case2 |
- Coolant temperature signal variation since engine Start is lower than 2.25 °C (4°F)
|
| Diagnostic Time |
|
| MIL ON Condition |
|