DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Detecting Condition |
| DTC Strategy |
Case1 |
- Intake manifold model filtered reduced area controller out of range (low load)
|
|
| Case2 |
- Intake manifold model filtered ambient pressure controller out of range (high load)
|
| Enable Conditions |
Case1 |
- Pressure quotient (manifold pressure, ambient pressure) is lower than 0.8
- Engine speed during engine start higher than 640 to 960RPM (Engine operating state out of engine start)
- Battery voltage is higher than 11V and lower than 16V
|
| Case2 |
- Pressure quotient (manifold pressure, ambient pressure) is higher than 0.8
- Engine speed during engine start higher than 640 to 960RPM (Engine operating state out of engine start)
- Battery voltage is higher than 11V and lower than 16V
|
| Threshold Value |
Case1 |
- Filtered reduced area controller is higher than 40 to 130% and lower than -130 to -40% (Versus ambient pressure, throttle opening position)
|
| Case2 |
- Filtered reduced area controller is higher than 20 to 30% and lower than -30 to -20% (Versus ambient pressure value)
|
| Diagnostic Time |
|
| MIL ON Condition |
|