LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Engine Control System Diagnosis - 2.0L (1 Of 6)) >> DTC P0011-00: 'A (Intake)' Camshaft Position - Timing Over-Advanced Or System Performance (Bank 1) >> DTC Inspection >> Monitor KDS Data

Monitor KDS Data

WARNING: This page is about a different variant/trim than selected.
Inspection Condition Inspection Procedure Reference
  1. Engine "ON".
  2. Warm up the engine to normal operating temperature.
  1. Connect KDS to "Data Link Connector (DLC)".
  2. Monitor parameters in "Current Data" with KDS.
 Fig.1
G13291197Courtesy of KIA MOTORS AMERICA, INC.

Good 

  1. Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Repair " procedure.

No Good 

  1. Go to "System Inspection " procedure.
scientia non olet · About LEMON Manuals