LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Engine Control System Diagnosis - 2.0L (1 Of 6)) >> DTC P000A-00: 'A' Camshaft Position Slow Response Bank 1 >> DTC Inspection >> Monitor KDS Data

Monitor KDS Data

WARNING: This page is about a different variant/trim than selected.
Inspection Condition Inspection Procedure Reference
  1. Engine "ON".
  2. Warm up the engine to normal operating temperature.
  1. Connect KDS to "Data Link Connector (DLC)".
  2. Monitor parameters in "Current Data" with KDS.
 Fig.1 to 2
G13291183Courtesy of KIA MOTORS AMERICA, INC.
G13291184Courtesy of KIA MOTORS AMERICA, INC.

Good 

  1. Fault might be intermittent and caused either by poor contact in connectors or wiring connector, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
  2. Repair or replace as necessary and then go to "Verification of Repair " procedure.

No Good 

  1. Go to "Wiring Inspection " procedure.
scientia non olet · About LEMON Manuals