DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Deviation check between actual cam position and cam setpoint position in case of changing setpoint (Slow response of actuator)
|
- Poor connector connection
- Faulty cam phaser
- Faulty intake CVVT assembly
|
| Enable Conditions |
- Camshaft set-point movement more than 8° within in less than 1s
- Camshaft set-point moved more than 0 times since engine start
- Engine speed at between 450RPM and 5000RPM
- Engine oil temperature at between 20°C (68°F) and 120°C (248°F)
- Battery voltage at between 11V and 16V
|
| Threshold Value |
- Composition movement less than 2.67° within 1s
|
| Diagnostic Time |
|
| MIL ON Condition |
|