Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- Refer to appropriate service information and visually and/or physically inspect following conditions:
- Vacuum hoses for splits, kinks and improper connections.
- Positive crankcase ventilation valve for improper installation, damaged o-rings and malfunction.
- Good PCM ground connections.
- Contamination, deterioration, poor connection or damaged MAP Sensor and ETC Sensor connector.
- Has any problems been found?
Good
- Go to "Three-Way Catalytic Converter Inspection " procedure.
No Good
- Repair as necessary and than go to "Verification of Repair " procedure.