DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy	Case1	TPS adaptation condition check	Poor connection or damaged connector Faulty ETC motor Faulty TPS
	Case2	ETC Limp Home position check
	Case3	Lower mechanical stop adaptation voltage range check
Enable Conditions		During TPS adaptation
Threshold Value	Case1	TPS adaptation is requested but not possible
	Case2	Difference between throttle sensor voltage in limp home and limp home setpoint is higher than 0.3V
	Case3	Difference between throttle sensor voltage in lower mechanical stop position and lower mechanical stop position setpoint is higher than 0.3V
Diagnostic Time		1.2s
MIL ON Condition		1 driving cycle