Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Start relay connector | 3 (start switch input) | Chassis ground | - | Approx. 0V |
| Start relay connector | 5 (start relay control) | Chassis ground | - | Approx. 2.5V | |
|
PCM connector | 66 (start switch input) | Battery (+) terminal | - | ∞ (infinity)Ω |
| PCM connector | 51 (ISG start motor control) | Battery (+) terminal | - | ∞ (infinity)Ω | |
| PCM connector | 34 (start relay control) | Battery (+) terminal | - | ∞ (infinity)Ω | |
Good
- Go to "Component Inspection " procedure.
No Good
- Repair or replace as necessary and then go to "Verification of Repair " procedure.