DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Pressure system rationality
|
- Open or short circuit
- Faulty driven pulley pressure sensor
- Faulty hydraulic system
|
| Enable Condition |
- Battery voltage is higher than 10V
- Engine speed is higher than 350RPM
- No CAN error
- Solenoid condition "ON"
- Torque signal state (from engine) is normal
- Pulley safety torque change "ON"
- APS is lower than 0%
- Lever Position "D", "Sport"
- Brake "ON"
- Secondary pulley speed is 0RPM
- No solenoid cleaning
|
| Threshold Value |
- Deviation between target secondary pulley press and current secondary pulley press is higher than 7bar
|
| Detecting Time |
|
| Fail Safe |
|
| MIL ON Condition |
|