DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy		Monitor the circuit (Check the open circuit and short circuit)	Open or short circuit Faulty driven pulley pressure sensor Faulty PCM
Enable Condition	Case 1	Battery voltage is higher than 10V Engine speed is higher than 350RPM Lever position in "D" or "Sports" (forward gear) Oil temperature is higher than 0°C (32°F)
Enable Condition	Case 2	Battery voltage is higher than 10V Engine speed is higher than 350RPM Solenoid "ON" APS is less than 0%
Threshold Value	Case 1	The output voltage of the sensor is between 2.5V and 3.5V
Threshold Value	Case 2	Difference between the target driven pulley pressure and the actual driven pulley pressure is higher than 4bar
Detecting Time		6s
Fail Safe		Limited learning
MIL ON Condition		2 driving cycles