Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

Courtesy of KIA MOTORS AMERICA, INC.

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	ATM solenoid valve connector	13(+)	Chassis ground	-	Approx. 5V
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	ATM solenoid valve connector	9(-)	Chassis ground	-	Approx. 0V

Good

No Good

Repair open or short in circuit between ATM solenoid and PCM and then go to "Verification of Repair " procedure.