DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy		Noisy signal monitoring	Poor connector connection Short to battery in fuel level sender signal circuit Faulty fuel sender
Enable Condition	Case1	Vehicle speed higher than 35.4km/h (22mph) 300s after engine start Vehicle speed gradient more than 1.8% during 20s Battery voltage higher than 11V and lower than 16V
Enable Condition	Case2	Evaporative system leakage monitor status waiting period or leak check period
Threshold Value	Case1	Difference between measured fuel tank level and filtered fuel tank level higher than 45%
Threshold Value	Case2	Difference between filtered fuel tank level and raw fuel tank level higher than 12 to 14%
Diagnostic Time	Case1	50 step (5s 100 counts)
Diagnostic Time	Case2	25 step (2.5s 100 counts)
MIL ON Condition		2 driving cycles