Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the crash pad lower panel.
(Refer to Body - "CRASH PAD LOWER PANEL ")
- Remove the clutch master cylinder.
(Refer to Clutch System - "CLUTCH MASTER CYLINDER ")
- Disconnect the Ignition & clutch switch connector (A).
- Remove the clutch pedal assembly (A) after loosening the mounting nuts (B).
Tightening torque:
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 Ib.ft)