LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Clutch System - 2.0L) >> Clutch Cover And Disc >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • If reinstalling used cover, the cover should be installed with its clutch disc as a set.
  1. Apply grease on a disc spline part and transaxle input shaft spline part as required.

    Specified grease  : CASMOLY L9508

    Amount  : 0.1 - 0.3 g

    NOTE:
    • When not applying: Excessive wear of splines and bad clutch operation can occur.
    • When applying excessively: Grease can be spread by the centrifugal force which can contaminate the clutch disc. This can cause a loss of friction force causing a slip.
    G13283896Courtesy of KIA MOTORS AMERICA, INC.
  2. Install the clutch disc and the cover with special tool (09411-1P000).
    NOTE: Possible problems when the disc is installed in the opposite direction.
    • Transaxle shift error or a strange sound can occur due to clutch separation.

    Gasoline 2.0  : The 'FLYWHEEL SIDE' marked surface should face the flywheel.
    G13283897Courtesy of KIA MOTORS AMERICA, INC.
  3. Install the clutch cover bolts.

    Tightening torque 

    Gasoline 2.0  : 11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb.ft)

    NOTE:
    • Install the all the components with the specified torques. If not, the clutch torque transaxle may have concerns or the mounting bolt can loosen.
    • When installing the clutch cover assembly, check the fastening order for each number of bolts and tighten the bolts loosely. Then, fasten the bolts to their proper tightening torque. This can prevent twisting and vibration of the cover, and lifting of the pressure plate.

      Fastening order for each number (6 or 9) of bolts for installing the clutch cover assembly

      Fig 1: Clutch Cover Bolts Tightening Sequence
      G13283898Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the clutch disc guide special tool (09411-1P000).
    G13283899Courtesy of KIA MOTORS AMERICA, INC.
  5. Install the transaxle assembly.

    G 2.0 MPI NU(ATKINSON) (Refer to Manual Transaxle System - "MANUAL TRANSAXLE ")

scientia non olet · About LEMON Manuals