LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Hydraulic System - 2.0L) >> Damper Clutch Control Solenoid Valve (D/C_VFS >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Intelligent Variable Transmission (IVT) is composed of delicate components. Be careful not to cause any damage on the component when assembling and disassembling.
  • Maintain clean condition so that foreign substance does not get into the Intelligent Variable Transmission (IVT).
  • Use a coated apron, latex gloves, and stainless tray to prevent foreign substance from getting into the Intelligent Variable Transmission (IVT).
  1. Install the damper clutch control solenoid valve (A).
    G00599908
  2. Install the support bracket (A).

    Tightening torque : 

    9.8 - 11.8 N-m (1.0 - 1.2 kgf-m, 7.2 - 8.7 lb-ft)

    G00599928
  3. Install the E-Module

    (Refer to IVT Control System -  E-MODULE

  4. Perform the procedures below after replacing the damper clutch control solenoid valve.
    1. Clear the diagnostic trouble codes (DTC) using the KDS.

      (Disconnecting the battery negative terminal will not clear the DTCs. Clear DTCs using the KDS at all times.)

    2. Reset the intelligent variable transmission adaptive values using the KDS.
      G00599909
    3. Perform the TCM adaptive values learning procedure.

      (Refer to IVT Control System - REPAIR PROCEDURES ).

scientia non olet · About LEMON Manuals