LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Front View Camera Diagnosis) >> DTC C2722-46: System Out Of Calibration >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
Inspection Condition Inspection Procedure Reference
  1. Ignition "ON". (with calibration target)
  1. Connect KDS to "Data Link Connector (DLC)".
  2. Perform "Vehicle S/W Management" of concerned component with KDS.
 Fig.1 to 9

■ In cases that require the calibration 

  1. In case of MFC ECU replacement.
  2. In case MFC ECU is removed from the windshield or bracket.
  3. In case of windshield replacement.
  4. In case MFC bracket is damaged.

■ Calibration procedure 

  1. Check for vehicle alignment and tire pressure for accurate camera calibration.
  2. Windshield must be clean and free of any dirt or object.
  3. Calibration target installation procedure as follows:
    1. Set the calibration target height approx. 88 to 92cm from the ground and align the center of target with center line of vehicle.
    2. Center of target and center of vehicle should be within -5 to +5cm
    3. Position the calibration target approx. 0cm from the center of vehicle front wheel. Horizontal line of vehicle and horizontal line of calibration target angle should be within 1 degree. (close range target setting)
    4. Perform distance target setting after performing close target setting.
    5. Position the calibration target 1.2 m from the front bumper. Horizontal line of vehicle and horizontal line of calibration target angle should be within 1 degree. (far range target setting)
G13287699Courtesy of KIA MOTORS AMERICA, INC.
G13287700Courtesy of KIA MOTORS AMERICA, INC.
G13287701Courtesy of KIA MOTORS AMERICA, INC.
G13287702Courtesy of KIA MOTORS AMERICA, INC.
G13287703Courtesy of KIA MOTORS AMERICA, INC.
G13287704Courtesy of KIA MOTORS AMERICA, INC.
G13287705Courtesy of KIA MOTORS AMERICA, INC.
G13287706Courtesy of KIA MOTORS AMERICA, INC.
G13287707Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition Inspection Procedure Reference
  1. Ignition "ON". (without calibration target)
  1. Connect KDS to "Data Link Connector (DLC)".
  2. Perform "VEHICLE S/W MANAGEMENT " of concerned component with KDS.
 Fig.1 to 5
G13287708Courtesy of KIA MOTORS AMERICA, INC.
G13287709Courtesy of KIA MOTORS AMERICA, INC.
G13287710Courtesy of KIA MOTORS AMERICA, INC.
G13287711Courtesy of KIA MOTORS AMERICA, INC.
G13287712Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals