LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Cylinder Head Assembly - 1.6L) >> Cylinder Head Cover >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover.

    (Refer to Engine and Transmission Assembly - "ENGINE COVER ")

  2. Disconnect the battery negative terminal.
  3. Remove the air cleaner assembly.

    (Refer to Intake and Exhaust System - "AIR CLEANER ")

  4. Disconnect the engine wiring connector and harness clamp and then remove the cylinder head protector and wiring from the cylinder head cover.
    G13280406Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the exhaust oil control valve (OCV).

    (Refer to Engine Control/Fuel System - "CVVT OIL CONTROL VALVE ")

  6. Remove the ignition coil.

    (Refer to Engine Electrical System - "IGNITION COIL ")

  7. Disconnect the positive crankcase ventilation (PCV) hose (A).
    G13280407Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the high pressure fuel pump.

    (Refer to Engine Control/Fuel System - "HIGH PRESSURE FUEL PUMP ")

  9. Remove the cylinder head cover (A), gasket (B).
    G13280408Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Cylinder Head Assembly-Cylinder Head Cover-Repair procedures
    Fig 1: Cylinder Head Cover Bolts Loosening Sequence
    G13280409Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals