LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Maintenance) >> Power Train >> Cooling System >> Repair Procedures >> [Engine Coolant Filling Mode] >> * Conditions for Deactivating the Filling Mode

* Conditions for Deactivating the Filling Mode

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
  1. The coolant temperature is 90°C (194°F) or above.
  2. The filling mode stop option is selected in the diagnostic device.
  3. The conditions for entering the filling mode are not satisfied.
  4. A filling mode abort condition occurs such as an ECT heater failure or a WTS failure.
    CAUTION: Don't accelerate the engine.
  1. Install the radiator cap and fill the reservoir tank to the "MAX"+0.4L (or "FULL"+0.4L) line with coolant.
  2. Stop the engine and wait coolant gets cool.
  3. Repeat 8 to 10 until the coolant level doesn't fall any more, bleed air out of the cooling system.
    NOTE: It takes time to bleed out all the air in the cooling system. Refill coolant when coolant gets cool completely, then recheck the coolant level in the reservoir tank for 2~3 days after replacing coolant.

    Coolant capacity: 

    Approx. 5.5 L (1.45 U.S.gal., 5.81 U.S.qt., 4.48 Imp.qt.)

scientia non olet · About LEMON Manuals