Repair Procedures: Disassembly

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ball joint after loosening the nut (A).
Tightening torque:

117.7 - 137.3 N.m (12.0 - 14.0 kgf.m, 86.6 - 101.3 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
NOTE:
- Using a plastic hammer, remove the ball joint.
- Do not to damage to the lower arm.
Courtesy of KIA MOTORS AMERICA, INC.
Install a new ball joint and then tighten the nut (A).

Tightening torque:

117.7 - 137.3 N.m (12.0 - 14.0 kgf.m, 86.6 - 101.3 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.

NOTE: When replace the ball joint with a new one, insert the bolt(A) into the ball joint with a certain pressure.
Insert the bolt to the ball joint without any gap.

Courtesy of KIA MOTORS AMERICA, INC.