LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Engine And Transmission Assembly (R & I) - 1.6L) >> Engine And Transmission Assembly >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation is in the reverse order of removal.
  2. Refill with the engine oil.

    (Refer to Lubrication System - "ENGINE OIL ")

  3. Refill the radiator with coolant.

    (Refer to Cooling System - "COOLANT ")

    Perform the following

    • Adjust shift cable
    • Refill transaxle with transaxle fluid.
    • Inspect for fuel leakage.
      • After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
      • Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
    • Clean battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent corrosion.
scientia non olet · About LEMON Manuals