[Bank 1/Exhaust]
WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
- Disconnect the camshaft position sensor connector (A).
- Remove the sensor by loosening the mounting bolt (B).
Camshaft position sensor mounting bolt:
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)
- Install in the reverse order of removal.
NOTE:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
- Apply the engine oil to the O-ring.
- Insert the sensor in the installation hole and be careful not to damage.
- Be careful not to damage the sensor housing and the connector.
- Be careful not to damage the O-ring.