Removal & Installation
WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
- Disconnect the accelerator position sensor connector (A).
- Remove the installation nuts and then remove the accelerator pedal module (B).
Tightening torque:
12.7 - 15.7 N.m (1.3 - 1.6 kgf.m, 9.4 - 11.6 lb.ft)
- Install in the reverse order of removal.