Removal And Installation

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency.

Drain the engine coolant.
(Refer to Cooling System - "COOLANT ")
Remove the radiator lower hose (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the water inlet fitting (A).
Tightening torque:

18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Remove the thermostat (A).

Courtesy of KIA MOTORS AMERICA, INC.

Install in the reverse order of removal.

NOTE: Place the thermostat with the jiggle valve (A) upward.

Courtesy of KIA MOTORS AMERICA, INC.

Fill with the engine coolant.
(Refer to Cooling System - "COOLANT ")
Start engine and check for leaks.