Sensor Circuit Inspection
WARNING: This page is about a different car, the 2025 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
| 1. Ignition "OFF". 2. Disconnect the electrical connector(s) from the ATS. |
ATS connector | 2 (ground) | Chassis ground | - | Approx. below 1Ω |
| 1. Ignition "OFF". 2. Disconnect the electrical connector(s) from the ATS. 3. Ignition "ON". |
ATS connector | 1 (signal) | Chassis ground | - | Approx. 5V |
Good
- • Go to "CAN communication Line Inspection" procedure.
No Good
- Repair open or short in circuit and then Go to ("Verification Of Repair ") procedure.