LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Engine Control System Diagnosis - 2.0L (1 Of 6)) >> DTC P0032-00: HO2S Heater Control Circuit High (Bank 1/Sensor 1) >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
Inspection Condition Inspection Procedure Reference
  1. Engine "ON".
  1. Connect KDS to "Data Link Connector (DLC)".
  2. Perform "Actuation Test" of concerned component with KDS.
 Fig.1
G13291230Courtesy of KIA MOTORS AMERICA, INC.

Good 

  1. Go to "Inspect HO2S (Bank1, Sensor1) Heater" procedure.

No Good 

  1. Repair or replace as necessary and then go to "Verification of Repair " procedure.
Inspect HO2S (Bank1, Sensor1) Heater
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "OFF".
  2. Disconnect HO2S (Bank1, Sensor1) connector.
 HO2S (Bank1, Sensor1) heater (component side) 2 (power) HO2S (Bank1, Sensor1) heater (component side) 5 (heater) Approx. 2.4 to 4.0Ω (20°C (68°F))

Good 

  1. Go to "Verification of Repair " procedure.

No Good 

  1. Carefully re-do this troubleshooting guide steps.
  2. If no problems were found with the circuits or connectors, replace the HO2S (Bank1, Sensor1) and go to "Verification of Repair " procedure.
scientia non olet · About LEMON Manuals