DTC Information: DTC Detecting Condition

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.

Item		Detecting Condition	Possible Cause
DTC Strategy		Heater performance check	Poor connector connection Faulty HO2S (Bank 1, Sensor 1) heater
Enable Conditions	Case 1	Battery voltage is between 10.7 and 16.1V Time after sensor heating is less than 35s Internal resistance signal is valid
	Case 2	Battery voltage is between 10.7 and 16.1V EGT around FO2S (model) is more than 450°C (842°F) Power of sensor heating is more than 90% Sensor heating time is more than 50s Fuel system status is no fuel cut-off over 50s Internal resistance signal is valid
	Case3	Battery voltage is between 10.7 and 16.1V EGT around FO2S (model) is more than 450°C (842°F) Sensor heating time is more than 50s Fuel system status is no fuel cut-off over 50s Internal resistance signal is valid
Threshold Value	Case 1 (start phase diagnosis)	Ceramic temperature is less than 755°C (1, 391 °F) for 35s after heating start
	Case 2 (permanent diagnosis)	Ceramic temperature is less than 755°C (1, 391 °F)
	Case3 (low temperature diagnosis)	Ceramic temperature is less than 630°C (1, 166°F)
Diagnostic Time	Case 1	3s
	Case 2	60s
	Case3	10s
MIL ON Condition		2 driving cycles