Circuit Inspection

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.

G13289708

Courtesy of KIA MOTORS AMERICA, INC.

G13289709

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	Gate select actuator connector	3 (power)	Chassis ground	-	Approx. 8.7V
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	Input speed sensor connector	1 (power)	Chassis ground	-	Approx. 8.7V
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	Clutch actuator connector	2 (power)	Chassis ground	-	Approx. 8.7V
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	Shift actuator connector	1 (power)	Chassis ground	-	Approx. 8.7V

Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace TCM and then go to "Verification of Repair " procedure.

No Good

Repair open or short in circuit between sensor power and TCM and then go to "Verification of Repair " procedure.