Circuit Inspection
WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
A/C control module (auto) connector | 33 (P-CAN high) | Chassis ground | - | Fig. 1 |
| A/C control module (auto) connector | 34 (P-CAN low) | Chassis ground | - | ||
|
A/C control module (manual) connector | 23 (P-CAN high) | Chassis ground | - | Fig. 1 |
| A/C control module (manual) connector | 24 (P-CAN low) | Chassis ground | - | ||
|
A/C control module (auto) connector | 33 (P-CAN high) | ECM connector (G1.6TGDI GAMMA) | 85 (P-CAN high) | Approx. below 1Ω |
| A/C control module (auto) connector | 33 (P-CAN high) | PCM connector (G2.0MPI ATKINSON NU) | 77 (P-CAN high) | Approx. below 1Ω | |
| A/C control module (auto) connector | 34 (P-CAN low) | ECM connector (G1.6TGDI GAMMA) | 63 (P-CAN low) | Approx. below 1Ω | |
| A/C control module (auto) connector | 34 (P-CAN low) | PCM connector (G2.0MPI ATKINSON NU) | 60 (P-CAN low) | Approx. below 1Ω | |
| A/C control module (manual) connector | 23 (P-CAN high) | ECM connector (G1.6TGDI GAMMA) | 85 (P-CAN high) | Approx. below 1Ω | |
| A/C control module (manual) connector | 23 (P-CAN high) | PCM connector (G2.0MPI ATKINSON NU) | 77 (P-CAN high) | Approx. below 1Ω | |
| A/C control module (manual) connector | 24 (P-CAN low) | ECM connector (G1.6TGDI GAMMA) | 63 (P-CAN low) | Approx. below 1Ω | |
| A/C control module (manual) connector | 24 (P-CAN low) | PCM connector (G2.0MPI ATKINSON NU) | 60 (P-CAN low) | Approx. below 1Ω | |
| A/C control module (auto) connector | 33 (P-CAN high) | Chassis ground | - | ∞ (infinity)Ω | |
| A/C control module (auto) connector | 34 (P-CAN low) | Chassis ground | - | ∞ (infinity)Ω | |
| A/C control module (manual) connector | 23 (P-CAN high) | Chassis ground | - | ∞ (infinity)Ω | |
| A/C control module (manual) connector | 24 (P-CAN low) | Chassis ground | - | ∞ (infinity)Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and go to "Verification of Repair " procedure.
No Good
- Repair open or short in circuit and then go to "Verification of Repair " procedure.
- If no problems were found with the circuits or connectors, replace the ECM/PCM or A/C control module and go to "Verification of Repair " procedure.