Inspection Procedure

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.

Check fuses and relays.
Check battery terminals and charge status.
Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Good
1. Go to "Circuit Inspection " procedure.
No Good
1. Repair as necessary and then go to "Verification of Repair " procedure.

G13284577

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	Passenger temperature actuator connector	5 (power)	Chassis ground	-	5V
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	Passenger temperature actuator connector	7 (ground)	Chassis ground	-	Approx. below 1Ω
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component and A/C control module.	Passenger temperature actuator connector	6 (feedback)	A/C control module (auto) connector	1 (feedback)	Approx. below 1Ω
	Passenger temperature actuator connector	6 (feedback)	Chassis ground	-	∞ (infinity)Ω

Good

Go to "Component Inspection " procedure.

No Good

Repair open or short in circuit and then go to "Verification of Repair " procedure.