Circuit Inspection

G13287068

Courtesy of KIA MOTORS AMERICA, INC.

APS1 Circuit Inspection
Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	APS connector	4 (supply)	Chassis ground	-	Approx. 5V
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	APS connector	2 (ground)	Chassis ground	-	Approx. below 1Ω
	APS connector	3 (signal)	ECM connector	14 (signal)	Approx. below 1Ω
	APS connector	3 (signal)	Chassis ground	-	∞ (infinity)Ω
	APS connector	3 (signal)	Battery (+) terminal	-	∞ (infinity)Ω

APS2 Circuit Inspection
Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	APS connector	2 (supply)	Chassis ground	-	Approx. 5V
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	APS connector	1 (ground)	Chassis ground	-	Approx. below 1Ω
	APS connector	6 (signal)	ECM connector	77 (signal)	Approx. below 1Ω
	APS connector	6 (signal)	Chassis ground	-	∞ (infinity)Ω
	APS connector	6 (signal)	Battery (+) terminal	-	∞ (infinity)Ω

Good

Go to "Component Inspection " procedure.

No Good

Repair or replace as necessary and then, go to "Verification of Repair " procedure.