Component Inspection

Inspection Condition	Inspection Procedure	Reference
Engine "ON".	Connect KDS to "Data Link Connector (DLC)". Perform "Actuation Test" of concerned component with KDS.	Fig.1

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	connector	Terminal	connector	Terminal	Specification
Ignition "OFF". Disconnect PCSV connector.	PCSV connector	1 (power)	PCSV connector	2 (control)	Approx. 18.5 to 22.5 (20°C(68°F))

Good

No Good

Carefully re-do this troubleshooting guide steps.
If no problems were found with the circuits or connectors, replace the PCSV and go to "Verification of Repair " procedure.