Circuit Inspection
| CKPS Circuit Inspection (W/O ISG) | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| connector | Terminal | connector | Terminal | ||
|
CKPS connector | 1 (ground) | Chassis ground | - | Approx. 2.5V |
| CKPS connector | 2 (signal) | Chassis ground | - | Approx. 2.5V | |
|
CKPS connector | 1 (ground) | CKPS connector | 2 (signal) | ∞ (infinity)Ω |
| CKPS connector | 1 (ground) | Chassis ground | - | ∞ (infinity)Ω | |
| CKPS connector | 2 (signal) | Chassis ground | - | ∞ (infinity)Ω | |
| CKPS connector | 1 (ground) | Battery (+) terminal | - | ∞ (infinity)Ω | |
| CKPS connector | 2 (signal) | Battery (+) terminal | - | ∞ (infinity)Ω | |
| CKPS Circuit Inspection (With ISG) | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| connector | Terminal | connector | Terminal | ||
|
CKPS connector | 3 (power) | Chassis ground | - | Approx. 5V |
| CKPS connector | 2 (signal) | Chassis ground | - | Approx. 4.7V | |
|
CKPS connector | 1 (ground) | Chassis ground | - | Approx. below 1Ω |
Good
- Go to "Component Inspection " procedure.
No Good
- Repair or replace as necessary and then, go to "Verification of Repair " procedure.