Component Inspection

Inspection Condition	Inspection Procedure	Reference
Ignition "ON".	Connect KDS to "Data Link Connector (DLC)". Perform "Actuation Test" of concerned component with KDS.	Fig.1

Courtesy of KIA MOTORS AMERICA, INC.

Good 

• Go to "Verification of Repair " procedure.

No Good 

• Go to "Inspect RCV Control Solenoid Valve" procedure.

Inspect RCV Control Solenoid Valve
Inspection Condition	(+) Probe		(-) Probe		Specification
	connector	Terminal	connector	Terminal
Ignition "OFF". Disconnect RCV control solenoid valve connector.	RCV control solenoid valve (component side)	1 (power)	RCV control solenoid valve (component side)	2 (control)	Approx. 28.3 to 31.1Ω at 20°C (68 ° F)

Good 

• Go to "Inspect BPS" procedure.

No Good 

• Carefully re-do this troubleshooting guide steps.
• If no problems were found with the circuits or connectors, replace the RCV solenoid and go to "Verification of Repair " procedure.

Inspect BPS
Inspection Condition	Inspection Procedure	Reference
Engine "ON".	Connect KDS to "Data Link Connector (DLC)". Perform "Actuation Test" of concerned component with KDS.	Fig.1

Courtesy of KIA MOTORS AMERICA, INC.

Good 

• Go to "Check EWGA performance" procedure.

No Good 

• Carefully re-do this troubleshooting guide steps.
• If no problems were found with the circuits or connectors, replace the BPS and go to "Verification of Repair " procedure.

Check EWGA performance
Inspection Condition	Inspection Procedure	Reference
Ignition "ON".	Connect KDS to "Data Link Connector (DLC)". Perform "Actuation Test" of concerned component with KDS.	Fig.1

Courtesy of KIA MOTORS AMERICA, INC.

Good 

• Go to "Verification of Repair " procedure.

No Good 

• Carefully re-do this troubleshooting guide steps.
• If no problems were found with the circuits or connectors, replace the EWGA and go to "Verification of Repair " procedure.