Removal And Installation

Remove the engine room under cover.
(Refer to Engine and transmission Assembly - "ENGINE ROOM UNDER COVER ")
Remove the oil drain plug, and drain the oil into a container.
(Refer to Lubrication System - "ENGINE OIL ")
Disconnect the connector (A) and remove the oil pressure switch (B).

Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.

NOTE: When installing the oil pressure switch, apply seal lock to the thread.
Seal lock : THREEBOND 2403
Thickness : 0.2 - 0.4 mm (0.008 - 0.016 in.)

Courtesy of KIA MOTORS AMERICA, INC.