Removal And Installation: Notes

Disconnect the battery negative terminal.
Remove the air cleaner assembly.
(Refer to Intake and Exhaust System - "AIR CLEANER ")
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "ENGINE ROOM UNDER COVER ")
Remove the wiring clips (A) from the cooling fan.

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the RCV solenoid valve connector (A) and booster pressure sensor (BPS) connector (B).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the intercooler outlet hose (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the intercooler inlet hose & pipe (A).
Tightening torque

Hose clamp bolt:

4.9 - 6.9 N.m (0.5 - 0.7 kgf.m, 3.6 - 5.1 lb.ft, 43.4 - 60.8 lb.in)

(If equipped with a cap, tighten it until the cap is removed.)

Pipe mounting Bolt:

18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the cooling fan controller (PWM) connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the cooling fan assembly (A).
Tightening torque:

4.9 - 7.9 N.m (0.5 - 0.8 kgf.m, 3.6 - 5.8 lb.ft, 43.4 - 69.4 lb.in)

Courtesy of KIA MOTORS AMERICA, INC.