Handling Connectors

Make sure the connectors are clean and have no loose wire terminals.
Make sure multiple cavity connectors are packed with grease (except watertight connectors).
All connectors have push-down release type locks (A).

Courtesy of KIA MOTORS AMERICA, INC.
Some connectors have a clip on their side used to attach them to a mount bracket on the body or on another component. This clip has a pull type lock.
Some mounted connectors cannot be disconnected unless you first release the lock and remove the connector from its mounting bracket (A).

Courtesy of KIA MOTORS AMERICA, INC.
Never try to disconnect connectors by pulling on their wires; pull on the connector halves instead.
Always reinstall plastic covers.

Courtesy of KIA MOTORS AMERICA, INC.
Before connecting connectors, make sure the terminals (A) are in place and not bent.

Courtesy of KIA MOTORS AMERICA, INC.
Check for loose retainer (A) and rubber seals (B).

Courtesy of KIA MOTORS AMERICA, INC.
The backs of some connectors are packed with grease. Add grease if necessary. If the grease (A) is contaminated, replace it.

Courtesy of KIA MOTORS AMERICA, INC.
Insert the connector all the way and make sure it is securely locked.
Position wires so that the open end of the cover faces down.

Courtesy of KIA MOTORS AMERICA, INC.