LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Driveshaft Assembly >> Front Driveshaft >> Repair Procedures >> Bearing Bracket & Shaft Assembly

Bearing Bracket & Shaft Assembly

  1. Remove the front drive shaft.
  2. Remove the bearing bracket & shaft assembly (A).

    Tightening torque: 

    39.2 - 63.7 N.m (4.0 - 6.5 kgf.m, 28.9 - 47.0 lb.ft)

    G13281206Courtesy of KIA MOTORS AMERICA, INC.
  3. Install in the reverse order of removal.
  4. Check the front alignment.

    (Refer to Suspension System - "FRONT ALIGNMENT ")

scientia non olet · About LEMON Manuals