DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	Signal monitoring	Poor connector connection Open or short to ground in circuit of valve Abnormal solenoid valve operation Faulty ESC
Threshold Value	If the valve relay is switched on and corresponding solenoid driver OFF, below condition last for 60ms ESC valve: solenoid voltage is lower than 2.0V If the valve relay is switched off and corresponding solenoid driver ON, below condition last for 60ms ESC valve: solenoid voltage is higher than 1.4V If the valve relay is switched on and corresponding solenoid driver ON, below condition last for 60ms ESC valve: solenoid current is higher than 6 to 11A
Warning Lamp	EBD/ESC/DBC/AVH warning lamp "ON"
Disable Condition	Ignition "OFF" and then "ON"