| DTC Strategy |
|
- Poor connector connection
- Open or short to ground in valve relay circuit
- Low voltage on valve relay
- Faulty ESC
|
| Enable Condition |
- Ignition "ON"
- No related DTC is stored
|
| Threshold Value |
- If the valve relay is switched on and valve relay voltage is lower than 4.5 to 5.5V continuously for 60ms
- A failure is detected if the voltage difference between power side and load side of valve relay is greater than 0.85 to 1.15V for more than 60ms
- If the valve relay is switched off and valve relay voltage is higher than 5.5 to 6.5V or valve relay voltage is lower than 2 to 3V continuously for 60ms
|
| Disable Condition |
- Ignition "OFF" and then "ON"
|
| Warning Lamp |
- EBD/ESC/DBC/AVH warning lamp "ON"
|