| DTC Strategy |
|
- Poor connector connection
- Yaw rate (Ax) calibration is not performed correctly
- Faulty ACU
- Faulty ESC
|
| Enable Condition |
- Ignition "ON"
- No related DTC is stored
|
| Threshold Value |
- A failure is detected if the zero value calibration for G sensor is not done
- A failure is detected if the sensor replacement is detected
|
| Disable Condition |
|
| Warning Lamp |
- In case 4WD - ESC/DBC/AVH warning lamp "ON"
- DBC warning lamp is applied: ESC(ESP) warning lamp "OFF", DBC warning lamp "ON"
- DBC warning lamp is not applied: ESC(ESP) warning lamp "ON", DBC warning lamp "OFF"
|
| Failsafe |
|