LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs/ESC Diagnosis >> DTC C1237-02: Pressure Sensor - Other >> Component Inspection >> Inspection Procedure

Inspection Procedure

  1. Ignition "OFF".
  2. Connect KDS to "Data Link connector (DLC)".
  3. Ignition "ON".
  4. Select "Diagnostic Trouble Codes (DTCs)" mode.
  5. Using a KDS, Clear DTC.
  6. Operate the vehicle within DTC Detecting Condition in General Information.
  7. Select "Diagnostic Trouble Codes (DTCs)" mode again.
  8. Is the same DTC stored in the system?

    Good 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "Verification of Repair " procedure.

    No Good 

    • Carefully re-do this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, replace the ESC and go to "Verification of Repair " procedure.

    * In case of replacing ESC, perform following "Vehicle S/W Management" procedures

CAUTION: In case of replacing ESC, perform following procedures.
Inspection Condition Inspection Procedure Reference
  1. Auto Detected Configuration Reset (ESP (ESC) Only).
  2. Ignition "ON".
  1. Connect KDS to "Data Link connector (DLC)".
  2. Perform "Auto Detected Configuration Reset (ESP(ESC) Only)" in "Vehicle S/W management" with KDS.
 Fig.1 to 4
G13285643Courtesy of KIA MOTORS AMERICA, INC.
G13285644Courtesy of KIA MOTORS AMERICA, INC.
G13285645Courtesy of KIA MOTORS AMERICA, INC.
G13285646Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition Inspection Procedure Reference
  1. Variant Coding.
  2. Ignition "ON".
  1. Connect KDS to "Data Link connector (DLC)".
  2. Perform "Variant Coding" in "Vehicle S/W management" with KDS.
 Fig.1 to 6
G13285647Courtesy of KIA MOTORS AMERICA, INC.
G13285648Courtesy of KIA MOTORS AMERICA, INC.
G13285649Courtesy of KIA MOTORS AMERICA, INC.
G13285650Courtesy of KIA MOTORS AMERICA, INC.
G13285651Courtesy of KIA MOTORS AMERICA, INC.
G13285652Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition Inspection Procedure Reference
  1. Longitudinal G-sensor Calibration (HAC/DBC Only).
  2. Ignition "ON".
  1. Connect KDS to "Data Link connector (DLC)".
  2. Perform "Longitudinal G-sensor Calibration (HAC/DBC Only)" in "Vehicle S/W management" with KDS.
 Fig.1 to 5
G13285653Courtesy of KIA MOTORS AMERICA, INC.
G13285654Courtesy of KIA MOTORS AMERICA, INC.
G13285655Courtesy of KIA MOTORS AMERICA, INC.
G13285656Courtesy of KIA MOTORS AMERICA, INC.
G13285657Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals