Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Bumper antenna connector | 1 (power) | Chassis ground | - | ∞ (infinity)Ω |
| Bumper antenna connector | 2 (ground) | Chassis ground | - | Approx. below 1Ω | |
| Bumper antenna connector | 1 (power) | IBU connector | 12 (power) | Approx. below 1Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and go to "Verification of Repair " procedure.
No Good
- Repair open or short in circuit and then go to "Verification of Repair " procedure.
- If no problems were found with the circuits or connectors, replace the bumper antenna and go to "Verification of Repair " procedure.