Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
ECM connector (1.6 T-GDI) | 83 (K-Line IMMO) | IBU connector | 6 (K-Line IMMO) | Approx. below 1Ω |
| PCM connector (2.0 MPI ATKINSON) | 68 (K-Line IMMO) | IBU connector | 6 (K-Line IMMO) | Approx. below 1Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and go to "Verification of Repair " procedure.
No Good
- Go to "Component Inspection " procedure.