Inspection For Each Cause
- Abnormal vibration
- Make sure the mounting screws are properly tightened before replacing the speaker.
- Reinstall the speaker and check that the symptom is resolved.
- If the symptom does not disappear, replace the speaker with a new one.
- Noise
- Check that the speaker connector is properly connected and reinstall the connector if necessary.
- If noises occur in the radio mode, turn to the media player mode.
- If noises occur in both modes, replace the speaker with a new one.
Information
If noises occur only in the radio mode, the poor radio reception is the cause so do not replace the speaker.
- Poor working
- Check the plus (+) and negative (-) speaker terminals using an ohmmeter. If resistance is measured at the specified value shown below, the speaker operation is normal.
Front Door speaker : 2.0 Ω
Rear Door speaker : 4.0 Ω
Center speaker : 2.0 ± 0.3 Ω
Tweeter speaker : 4.0 ± 0.6 Ω
Midrange speaker : 2.0 ± 0.3 Ω
Sub woofer : 2.0 ± 0.3 Ω per coil (4.0 ± 0.6 Ω coil in series)
- If the measured resistance is different from the specified value, replace the speaker.