Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
MFC connector | 11 (L-CAN high) | Chassis ground | - | Fig.1 |
| MFC connector | 3 (L-CAN low) | Chassis ground | - | ||
Good
- If no problems were found with the circuits or connectors, replace the MFC ECU and go to "Verification of Repair " procedure.
* In case of replacing MFC ECU, perform following "System Inspection" procedures
No Good
- Repair open or short in circuit and then go to "Verification of Repair " procedure.