Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
MFC connector | 7 (ground) | Chassis ground | - | Approx. below 1Ω |
|
MFC connector | 5 (ON/START Input) | Chassis ground | - | B+ |
Good
- If no problems were found with the circuits or connectors, replace the MFC ECU and go to "Verification of Repair " procedure.
* In case of replacing MFC ECU, perform following "System Inspection" procedures
No Good
- Repair open or short in circuit and then go to "Verification of Repair " procedure.