Monitor DTC Status
| Inspection Condition | Inspection Procedure | Reference |
|---|---|---|
|
|
Fig.1 |
Active Fault
- Select HECU system and Check DTCs related with torque control. If DTC is exist, repair as necessary and then confirm clear. Afterward, select SCC system and check DTCs.
- Repair or replace as necessary and then go to "Verification of Repair " procedure.
History/Pending Fault
- Fault is intermittent caused by poor contact in the sensor's and/or control module's connector or was repaired and control module's memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
- Repair or replace as necessary and then go to "Verification of Repair " procedure.