LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Double Clutch Transmission Diagnosis - 1.6L (4 Of 4)) >> DTC U0100-87: Lost Communication With ECM/PCM >> Wiring Inspection >> Circuit Inspection

Circuit Inspection

WARNING: This page is about a different car, the 2021 Kia Soul. However, it is still accessible from the selected car via links, so may be relevant.
G13291136Courtesy of KIA MOTORS AMERICA, INC.
G13291137Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "ON".
TCM connector 44 (P-CAN high) Chassis ground - Fig.1
TCM connector 45 (P-CAN low) Chassis ground -
  1. Ignition "OFF".
  2. Disconnect the electrical connector(s) from the concerned component.
  3. Ignition "ON".
TCM connector 44 (P-CAN high) TCM connector 45 (P-CAN low) Approx. 60Ω
  1. Ignition "OFF".
  2. Disconnect battery (-) cable.
  3. Disconnect the electrical connector(s) from the concerned component.
ECM (component side) 85 (P-CAN high) ECM (component side) 63 (P-CAN low) Approx. 120Ω
ICU (component side) 12 (P-CAN high) ICU (component side) 11 (P-CAN low) Approx. 120Ω
G13291138Courtesy of KIA MOTORS AMERICA, INC.

Good 

No Good 

Module Circuit Inspection
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "OFF".
  2. Disconnect the electrical connector(s) from the concerned component.
  3. Ignition "ON".
ECM connector 4, 7 (Memory power) Chassis ground - Approx. 12V
  1. Ignition "OFF".
  2. Disconnect the electrical connector(s) from the concerned component.
  3. Ignition "ON".
ECM connector 1, 2, 3 (ground) Chassis ground - Approx. below 1Ω
  1. Ignition "OFF".
  2. Disconnect battery (-) cable.
  3. Disconnect the electrical connector(s) from the concerned component.
TCM connector 44 (P-CAN high) ECM connector 85 (P-CAN high) Approx. below 1Ω
  1. Ignition "OFF".
  2. Disconnect battery (-) cable.
  3. Disconnect the electrical connector(s) from the concerned component.
TCM connector 45 (P-CAN low) ECM connector 63 (P-CAN low) Approx. below 1Ω

Good 

No Good