LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Sorento L >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electric Parking Brake Diagnosis >> DTC C1604-04: ECU Hardware Error >> DTC Inspection >> Monitor KDS Data

Monitor KDS Data

  1. Connect KDS to Data Link Connector (DLC).
  2. Engine "ON".
  3. Monitor "Current (RH) - Cable" parameters in "Current Data" with KDS.

    Specification:  Non-control condition: Approx. 0 A

    G12840658Courtesy of KIA MOTORS AMERICA, INC.
  4. Is parameter displayed within specification?

    YES 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals